Just checked. Angle at 20 degree. I ordered a aftermarket HD cover. I'm going to give that a try. Tks for the info.
I finally welded in my rear perches on my 74 cj5, I'm using 2.5 wide 76 4" lift springs. I think the pinion angle is alot. My concern is won"t i...
I've got a set from my 74. D30 & D44 rear. The D30 has new ball joints. Both are bare axles. The backing plates are on the rear. They do need new...
Good idea on the cover. How much extra oil did you add?
Thanks for the info. I guess I'll relocate the perches. And I was hoping I was almost done.
I'v got a 74 CJ with 1976 wider 4" lift springs & a 1-1/2" shackle lift. I'v just received my new cv joint drive shaft and installed it. The cv...
I have a 74 cj5 that I'm installing power steering. I have the pump & all brackets. Can I use any year Saginaw steering box or does it have to be...
The freeze plugs were designed to drain the casting sand from the block when it is cast. They do work well to pop out when the block freezes and...
You don't need clamps to hold the wc pistons in place. They will not come out unless you apply pressure to the brakes. Start spraying up the brake...
The problem with pumping the brakes, is that if you have a air bubble in the line it gets broking into alot of small air bubbles. This makes it...
The best way is to start at the RR wheel. Fill the master cyl & put the cap on. Open the bleeder on the RR wheel cyl. Slowly push the brake bown...
The tank and sending unit are both from 4 wd hardware so they should be correct. The gauge is the stock one. I guess I'll pull the tank and do the...
Separate names with a comma.
