Wow, lots of great information. I just recently redid my dash and decided to take the speedo apart just to clean it. What a huge difference, looks...
You can buy TREs for a M38A1 too. They are the same taper as regular CJ ones but have a bigger .75 inch threaded shank. I used these, jam nuts and...
I just went with these.http://www.jcwhitney.com/wcsstore/jcwhitney/images/imagecache/G_21370G_CL_1.jpg $139 with free shipping from good ole...
Cool. Thanks for the feedback. I'll probably just get the replacement lowbacks.
Kind of an old thread, but I was looking at these from JCWhitney. Anybody have any experience with them?...
The high steer arm on the passenger side and a new drag link would probably be easiest, but you may not have clearance for it. If you don't think...
How much lift do you have? Spring over or spring under?
I would also try and run TRE's instead of Heims. I had to run a Heim on my pitman arm for a while, and as mentioned, it was always loose. I also...
There's always Ebay :D...
Oh yeah, Detroits and 4:88's. the front will get better joints and alloy shafts later. Not in the budget right now.
And the new front Dana 44. It started as a Dodge. I narrowed the passenger side 5 inches to run a Wagonner long side shaft. WMS to WMS is right at...
Here's the latest addition to my Jeep I've been working on. It started as an F-150 rear that I cut 5 inches off of the passenger side. That let me...
Hah! I was checking that out on CL too, but the wife said NO! R) Good luck with it. Also, there was a guy in my local club,...
Bob, I don't think you want to see any of the slip splines while the Jeep is at rest. All the spline section should be completely in the slip...
Separate names with a comma.