They are new ball studs, and yes i followed that procedure. The old ones were really tight, so it hard for me to judge how the new ones should...
Well found some time to work on the jeep today, putting the left front side back together. My question is after following the fsm procedure for...
Already done. 7/16 drill bit made the bolt slide through but fit nice and tight. I'm pretty sure the sleeves were not made to the correct specs...
I think the sleves dont have the correct ID they measure slightly less than 7/16" which is the size of the shackle bolts which are the same size...
Re: Enegry Susp. Bushings? That's what I was afraid of.
Re: Enegry Susp. Bushings? Yup, cut/hammered them out. The bushings fit in the shackle mount on the frame and the sleeves fit through the new...
I just got these for my 74 CJ5 (p/n22101) and the bolts that came with my shackles, which are the same size as the ones I removed, do not fit in...
The odd thing is that most of the damage is where the spindle seal seats. Everything spun like butter when I took it apart and there were no signs...
Well I started to disassemble the steering knuckle on my Dana 30 for ball stud/spindle bearing replacement. When I removed the seal on the spindle...
Hello All, been lurking for awhile, finally starting to work (spend money) on my Jeep, and was going to do a disc brake conversion. I was...
Separate names with a comma.