You guys have made me rethink my clutch cable solution. Maybe I need to try to find, or make, all the pieces to stay with the inlinetube type cable.
Thanks for the information. Is that in the FSM? That gives me options with my build. I'm constantly impressed with the knowledge here.
Ron, What is the distance from the centerline of the pivot to center of the cable attachment on the pedal arm? My pedal arm only has a spring...
How does the cable attach to the clutch pedal on the 71? Is the pedal attachment different from the 69? Pictures would be great if anyone has...
I have the bellhousing, transmission and transfer case from a 71 but I don't have the 71 clutch shaft and cable. I'm contemplating putting it in...
Can the long clutch cable on the 71 be converted to the shorter design like my 69 CJ has? Any problems with this change or things to consider...
Not sure what you mean by "one side is not used".
It is possible to install the shaft upside down, with the oil galley up instead of down, but that was not my case.
There was a lot of sludge in the shaft when I cleaned it. Maybe enough to starve the oil supply???
So, I've been working on my Dauntless V6 conversion and found one badly worn rocker arm shaft. Some of the rockers show excess wear, but the...
The factory speedometers had a thick grease on the gears to keep them from bouncing.
As soon as I figure out how to post pictures, I'll show the rack I built on the back to hold my doors.
Separate names with a comma.