I have a 59 F head I'm working on for a friend, #2 cyl. is dead and intermittently #1 as well. Plugs & piston tops in both cyls. are oil soaked...
I am looking for the part numbers for the molded radiator hoses for a Dauntless V6 in a flatty.
What type of cast material is the differential housing made of on the M20 NT axle? Iron, if so what type of iron, or is it cast steel? Also my...
I might be able to get an Offy 360 "eqal-flow" for my 225 OF. According to my research the 360 doesn't make power until 2000 on up to 7000rpm. I...
In my 48cj2a I am changing my front differential from the D25 to a D30. Is there any pit falls to watch out for or tips on doing this easily? For...
I have a 2wd B/O/P case TH475 (heavy duty diesel version of a TH400) I want to convert it to a 4wd. Will the output shaft and tail housing from an...
I am rebuilding my D25 and pulled the diff cover to find the ring gear is loose. When I try to spin the ring gear it will move a little on the...
'Does anybody have a picture of the 11"drum Ford front brakes. I am trying to figure which side is which.:?:roll:
I have a 48 cj2a with a dana 25 front axle that I am rebuilding and upgrading as I go. I have a good used set of Spicer style axles to install in...
I did a search before posting this but no luck. I am setting the preload on the king pins after installing new bearings and races. In order to...
I have a question about installing the spindle stud upgrade on a Dana 25. Is it worth the effort to use an end mill or counter bore to try to...
I have a 225 v6 in my CJ2A. I only have a story about where it came from. Supposedly the engine, trans, and t-case all were swapped in as a...
In my old tool box I found some NOS parts I can't remember what they are from. Does anybody recognize the part numbers? U-Joint Kaiser/Jeep...
I just bought a 48 CJ2a with a Buick/Jeep 225 V-6. ( I have not checked the casting numbers yet) It starts great, runs ok, a little lethargic IMO....
Separate names with a comma.