OK, I don’t mean to be a pest but driving a Jeep is new to me (check out my “Maiden Voyage” post) Anyway, I tried some panic stops at about 40...
After two years of work I took the maiden voyage in my ‘71 CJ5 today. Please keep in mind that I have never ever driven a Jeep before, so I have...
OK, new tank, new sender & new gas gauge. Needle pegs @ full.:( OHM reading on sender wire is only 2 ohms. When I put the tank in I upgraded to a...
Quick question. Installed a 12" 1650cmf pusher fan that draws 7 amps. Instructions say it should be connect to a 30 amp fuse (no problem there) I...
OK, have Delco 10 dn alternator... voltage regulator is marked F,2,3,4 I know that F & 2 attache to the alternator, 4 goes to the Alt light on...
After two year of work I’ll finally to the point of having a running JeepR) It started 1st try & runs well with no leaks & I have not even checked...
Original carb has place for threaded rod that hold down air cleaner, new carb does not. But judging from the holes it looks like their should be a...
In case anyone needs to see how it looks completes. Steering shaft kit, column collar, bushing & piece to mount steering box to frame all supplied...
Body went back on & bolted down todayR) Hope to be done by spring:)
Only have a fraction if an inch between blades & steering box. I'm sure that if their is any engine movement they are gonna hit:( Was thinking of...
OK, CJ5 with V6... It's getting very close to the time to look for a radiator. Getting the old one recored or a repo are too expensive. I've heard...
'71 CJ5... I want to use the miltary type pedals (the metal ones with the nubs) Would thier be any fitment issues or will they just bolt up to the...
Engine & T14 togeather & in frame. Output gear already installed on trans. Can I install the tranfer case with the transmission output gear...
..
Shoud I start over again with the same clutch that I bought or do it again with another new one? Here's what happened. Once clutch was...
Old 3 finger clutch setup is 1/2" taller than the diaphram set up. Is this a problem? Bearing for diaphram clutch is the correct Napa part # for...
Just in case someone needs it. With a 225 v6 & T14A trans you need this throw out bearing if you use diaphram clutch instead of the 3 finger one....
Just curious... Transferred output gear, top cover, shifting forks & cane from my old T14 to my new rebuilt on. Once I was able to see inside the...
The Fed Ex guy just delivered my rebuilt T14 from Herm the Overdrive GuyR):):p
I checked the engine code on mine it's 9 to 1 what grade of gas should I run:?
Separate names with a comma.