You never want to push in the clutch pedal on installation. The transmission should slide right in, without any force...well maybe just a little....
I know many people use lexan. Lightens the top up and it is easier to work with. If it was anything othet than an all original and rare CJ6 I...
The Ford's ring and pinion stock is twice as strong as a Dana 44 and stronger than a Dana 60 too. If they are 31 spline axles they are every bit...
If you are going to buy a new shaft anyhow, get one with a CV then point the rear end at the transfer case. Best way to do it, and they can set...
That is why ALL the serious comp rigs run them? There is no way I am going back to leafs. I broke almost enough to buy coilovers in the first...
Here is a better story http://www.pirate4x4.com/forum/showthread.php?t=258766&highlight=fordyce
First of all get rid of the three inch body lift. Then go to pirate 4x4 and buy a red star for $20 and DO NOT POST but search search search. When...
On my home computer I have a picture of water flowing through my doors(?), when crossing Fordyce Creek. I much prefer to know my brake fluid is...
The $27 only buys you the top part. You still would need to buy the jack. I too use jack stands and usually a stick of wood or last time I...
Did you search the internet? Google is your friend. http://collinsbros.stores.yahoo.net/239galsteelg.html Use the part number to find a cheaper...
There are plenty available including the factory one. What about just replacing the entire tank with a new one that is larger, and has a built in...
Taurus fan will kick most any mechanical fans butt especially at idle. They draw 60 amps at start up and about 20-30 amps continuous. Same fan...
So let me get this straight...you scrapped one of the weakest axles made for one of the strongest? Now why would you do that? :roll: :beer:...
So if you are gonna run 5 lug, you need the rare Chevy/Jeep small bearing spindles and I would just buy brand new Ford 1/2 ton rotors, as they are...
If you want to keep your stock pedals, then Herm's kit works. http://www.film.queensu.ca/CJ3B/Tech/BrakesDualMaster.html...
Forget checking the bushings, replace them! Just what kind of shackles are you running? Something the shackles like Confer's will have less flex...
Yes Cj5 pedals work. You might need to rebend the pedals around the column.
I am famous for modifying everything so...I went to the junk yard and found a pusher fan on a car, then mounted mine in front of the grill, zip...
I have YJ pedals ($25 shipped), and am using a Parts Mike Parts slave and master kit for the clutch and yet undecided on the power brake booster...
$450 is cheap. Custom axles alone are going to cost you more than that. Since there is no known production axle in those lengths and splines you...
Separate names with a comma.