Thanks again, I'll check everything out and get this fixed!
That was my first attempt, but I got a fast blinking with the blinker on and lights were very dim, seemed like a grounding problem??
Hey guys, Passenger side taillight quit working, replaced bulb, no dice. Followed wiring from tail light over to drivers side tail light and...
Great, thanks Uncamonkey!
Thanks for the help guys! I'll let you know how it goes.
I have the original Hall 701 tail lights on my 1966 CJ5, how do i get to the bulb to replace it? The retainer ring does not appear to be separate...
Based on a recommendation I got here on the forum some five years ago, I purchased these guys: Hercules HDT Bias Lug, they come in 7.00-15 and...
Definitely idling too high! Been meaning to get back under the hood and adjust the carb. Will look at the spring, good suggestion Mjragan, thanks!
Really running well guys, I'm going to leave it where it is, and if it diesels, I can keep doing what everyone suggests and what I have been doing...
Now have timing set to about 2 degrees and it runs great but I am still getting that dieseling when i shut it off. The motor keeps trying to run...
I'll take the idle down a bit and then reset the timing to 0 and see what that does, although mine is not a CA, at least not that I know of - how...
So I got back to it this afternoon and adjusted the timing down to about 5 and that took care of the engine knock but now it's seems to hesitate a...
We tried all that, moving it all around, but just too many obstacles! i think we have the wires right - after a try or two.... I'll check to see...
So here's an update on recent activities with my 66 CJ5/V6: 1. New battery 2. New battery cables 3. New Fan Belt 4. New fuel filter 5....
Everything is checking out just right. 1/8 inch toe-in now corrected from a full 1 inch prior to adjustment. It was all in the Front passenger...
Got everything measured up and adjusted today. We'll see how it goes on that tire! Drives fine. Thanks everybody!
Sorry, one last question, is there a proper torque value for the clamp bolts on the tie-rods? Thanks!
PS, added a pic of my Jeep in my Avatar, and brief description in my signature. Looks better!
Got it, that's what i was looking for! Been roaming around the forum and found some parts blow-ups of the tie rod assembly and now see it is...
It does have two tie rods, so sounds like ross set up. Just don't know how to do the actual adjustment, if you loosen the clamps, do you then...
Separate names with a comma.