I probably should have posted this on the Jeepster page but there isn't a lot of activity over there. I'm working on a 1967 Jeepster with the...
I purchased an 1/8" petcock to go in it which would not fit I also tried an 1/8" pipe nipple which was too big. I will try and post a picture of...
I am currently overhauling the V-6 in my 1967 Jeepster. The machine shop removed and subsequently lost the plug for the coolant drain plug for...
[IMG] [IMG] [IMG] [IMG] [IMG] This is a Trail Forge kit that I installed in my 1967 Jeepster. The kit was very well fabricated....
TrickPatrick, Concerning your springs, I just new springs made for my Jeepster at a Semi-Tractor trailer repair business. I had them add 2" of...
Here is a picture of the roll cage for my Jeepster. Its is a trail forge kit and it was pretty well fabricated. It took me a couple of evenings...
I didn't go with a radical lift on my Jeepster, just 1 1/2" to take the sag out of the rear end, but I had mine made at a heavy truck repair shop....
K&N makes a filter that will fit the 2GC Carb. It also has the fitting to connect the breater tube to. The part # through Summit is KNN-60-1070....
The bar came from Trail Forge. It is their Sport Bar kit.
What kind of lube do you put in the closed knuckle housing? The shop manual states universal joint lubrication, using #1 or #2, but I'm guessing...
Does anyone make a replacement Hub for the front end of a 1967 Jeepster. Mine still has the originals and I would like to install something a...
I thought I would give you guys an update on the Jeepster. I recently finished the installation of the Trail Forge Sport Bar in my Jeepster. The...
I'm located in South Central Nebraska. (Blue Hill)
Well, After a pop, a grinding noise, and then some poping noises I ended up with some broken teeth on the pinion gear of the rear end of my...
Does anyone have an opinion on the rate of advance for an HEI Distributor on the Dautnless. If you start out at 8 degrees advance and want to...
Ahhhh, Remanufactured Carburetor ????!!!!! I thought that maybe the port might be plugged also so I blew a little air through the port and got...
What does the correct base gasket look like? The one I used has two holes in it for the bolts to go through and the other side has an open area...
Guys, This weekend I had a few projects planned for my '67 Jeepster (see pictures previous thread). The projects included installing a...
The paint is PPG Base Coat Clear, it was there cross reference for the orginal Jeep red of that year. If you would like I could try to get the #....
Does anyone know if the sport bar kits provide much for roll-over protection? The 1 3/4" tubing seems kind of light. Terry
Separate names with a comma.