Welcome from the other side of the pond. SW Wisconsin. Your gonna like it here.
I'm picking my kit for my 68 MC tomorrow from NAPA. The front is a 1 inch bore and the back 7/8ths. My Jeep has drums on both ends and stock. I do...
Mineral spirits, no smell ...
It is not recommended to cut brake line with a tubing cutter. Use a saw, chamfer the tube then flare and blow it out before installing it. I used...
Nice fab job..Very well done..You guys can build your own. Gotta try guys..
I sold my old 10" craftsman table saw and old 10" miter compound, bought the cut off and with money to spare. Not doing any more carpenter work....
You guys got any thoughts on a Makita Chop Saw. It comes with a ($65)4.5 inch paddle grinder free. $185 with tax. Any bad press on the chop saw?...
Planning on using mine, then again, how may miles per day will also dictate whether you want to do the drive everyday. Maybe half time with the...
I emailed Rancho* a couple of times so far. :mad: With no R) answer. Any way guys, The aluminum spacers supplied with the lift kit are narrower...
Somewhere around 1976 to 82 I believe. Chevy had those sparkplug exhaust guards on the SBC. Been cut by them before, 1980 Chevy 4dht. Don't know,...
If your can has the old cover with the four curled edges. You may find a bike lock to go through it. Or as we did in Nam. Take the cap off and...
Naw, it thinks its a Zepplin. R)
I agree, as long as your rings don't travel below the piece thats missing. You'll have no problem. Also, be aware of short skirt pistons. The...
A little heat goes along way. Did the same thing your doing. Ended up removing the entire tub, lines and rebuilding the MC. Brake lines don't give...
Very nice, I'd slow the wire down just a tad..Or speed up. Mig takes practice.....but very nice for the first time in 20 years.
Yup, start with the grounds and also the relay contacts. I figure your pushing enough volts when you rev, I suspect the relay contacts. Run a wire...
You didn't mention if the starter drags when the engine is hot or cold or both. Simple test is to stop at any garage and put a draw on the...
A wire from the battery to the coil and a screwdriver will take about 30 seconds to leave your parking spot MT. How about a magnetic switch that...
MT the thing, seal it in a vacuum bag like you'd use for food. If there is no fuel in the carb. It isn't a HAZMAT problem. If you still have ?,...
Thanks Mike and the rest, Thats what I figured too. Our DOT:twisted: inspections around here consist of " ya ya Ole' da ting hass tirers and a...
Separate names with a comma.