OK the clutch cable broke while driving back from the paint shop the other night. Hey whats a 2 hour wait in 20 degrees just to be able to pay $90...
Any one know where to get a front bumper for a 69 commando. It is one of the last parts I need to finish off this project.
Well I finally got around to putting the D30 in tonight. I read Lynns write up on his install. I used the shims that I got from Mcruff. I also ran...
Well floor supports or hat channel, looks like I am going to need some. Has any one got any tips on replacement procedures. I have read up on the...
Here I thought I had a 225 odd fire. I went by the cast numbers in the tech section. the block number above the bell housing is 1254083. Best I...
Does any one have a good part number for the 71 225 valve cover gaskets? I have ordered 2 pair so far neither one of them have the corner that is...
Hi, I have looked through the threads for the info. I just got the mount from Krage the 939995 for the 71 v6. Has any one got a picture of this...
OK, I have a spare d18. I started cleaning it up tonight, its a twin stick so maybe I can use it. I cleaned it up some. The numbers on the front...
Does any one know the torque settings for the spindle nuts on a 76 d30. It has probley been discussed here before but I could not find it. Thanks
I am redoing my brakes for a 76 d30 swap. Can I use the 7/8 brake rotor instead of the origional 1 1/8. That I am taking off without...
Hey do you guys know of a decent shop that can do a gear change over in the area? Thanks
I have posted this in another form but anyhow. I just got a 76 d30 front end. It has the 6 bolt warn hubs and disc brakes with the 1 1/8 brakes....
Does any one have a measurement between the flairs for a 71? I am looking at getting a set of rock sliders fabricated. Since I do not have flairs...
Has anyone used these? I am just trying to get an idea about these.
I have to replace my quarter panel on the passenger side. The panel I got does not have the correct indention near the back, nor does the panel...
I know this has been covered a thousand times,, and I have read a lot of the articles. I went to look at some jeep parts, it was a 79 cj5. I...
How hard is it to install a locker in a 71 dana 44 rear?
what soft top works the best for the 71 cj5. :?
What is the advantage of the twin stick? :? When I got my 71 ,it had one the guy threw in with the sale. The PO bought it to get the front drive...
Separate names with a comma.