Thank you for the sanity check!
Have a '69 with a V6 - daily driver. I have been trying to get the very dim lit charging light to go out. Light is bright prior to turning over...
The pumps need to be packed with pretoroleum jelly for priming. I would also check the oil pump gasket to make sure you have a good seal.
Thanks - I was paranoid about it getting oil so I pulled it off just to check. Has a good supply of oil and it looks good. It did have the scoop....
Just put in a new Overdrive - it functions well with no apparent issues. Is it typical that they get HOT during operation? Drove the jeep about 20...
Float level - 5/32" Float drop - 1 5/8" Pump rod - 1 1/16 For 225 engine
Float adjustment was the fix - Thx
Thanks - will check level. Only had trouble with the float during rebuild. The specs made no sense, so I tried to compare to the original float setup.
We'll I just completed a rebuild on my 2bbl rochester 2g. The rebuild was successful to eliminate my hesitation on acceleration,but created...
Thanks for the reference - I didn't see a pic with the exact combination I have on my CJ5. Going to buy my OD from Herm - guessing he has a...
I have a '69 with stnd 3 speed tranny and single stick transfer. I'm going to install an overdrive and was wonder if anyone had some pictures of...
Does anyone have the OEM specs for a front-end alignment for a '69 CJ5?
Thanks - That's is exactly what I needed!!!!!!!!!
I can get my hands on an overdrive, but am questioning if this is something a very mechanical apt person can install? Have a '69 with factory...
Anyone know where the circuit breaker is located?- wiring is stock - never knew of a circuit breaker. would be a great place to start.
Thinking about a new wire harness - painless appears to be good option?
Using my 69 CJ5 as a daily driver- driving along with no issue then blackout - nothing electrical would work. Let it sit for a few minutes then...
Had the same problem.....I purchased about $50 in parts to fix the isssue. Ordered a new yoke as mine had a worn area on the shaft (check that)....
Separate names with a comma.