knowing what I know now I would pull the body off. A couple years ago I replaced my floors in my 5. I had rotted thru floors and left the body...
What are the plans for suspension? Linked hence the mounts but what springs? Looks awsome. I hope to get started on one someday for my 73.
Kind of got my interist on this frame thing. I too have a twisted cracked and messed up frame and body does not sit right. I thought about...
I went to harbor freight and bought a set of paint guns. I then went out and bought a gallon of rustoluem industrial safety red paint. The jeep...
I am thinking of swapping in a front and rear 44 out of a late 70s cherokee into a 73 cj5. As it sits now I have a 44 in the rear but narrow...
Well I went out to look at the tranny bushings and torque bushings. The tranny mount looks Ok. The torque bushing has a lower one and upper one....
Ok I have a 73 cj5 that has a 4.0 and t-18 with a dana 20 t-case. I just finished all the floors bodywork and paint and got it on the road. When...
fixed it! I got some shoulder bolts from work. They have a 5/8 round shaft and 1/2-13 thread on the end. I cut out the old stud and then...
I was pulling off the shocks on my 73 cj. The fronts came off no problem. The rear shock mount on the frame on the passanger side the stud...
I have a 73 cj and was looking to swap out the springs. It is spring over with 2 inch lift springs. Its a little to high and the driveshaft...
I don't have pics but I took some angle iron 1/8inch thick by 1inch by 1inch and ran two pieces down where the old rusted hat was. I redid the...
I measured mine when I was putting in a new rear floor and it was at around 36 inches. I have a 73 cj5
1.a few dozen tape measures (I loose alot of them) 2.Dust mask or resiperator (if you paint or grind bondo) 3.Combination square 4.fully...
Yes Please, Just in time :D n8sjh@msn.com Thanks
Separate names with a comma.