I am in the process of doing the front drum to disc conv. on my '71 and I am in need of some advise about the Master Cylinder. I was told that I...
In response to fixitcj5's question... I don't have a proportioning valve in the line. I thought the dual m/c was suppose to have one in it for...
I have a '71 that has been restored. still mostly stock. I am having a problem with the front brakes sticking/dragging. Dana 27 with drum...
I am having some issues with my brakes on my '71. Drums on all four corners.. I have replaced every component in the braking system. I got all the...
Thanks for all the advise. Almost positive that my 71 did not come with a stay-cable. I do have the "transfer case mount" though. The rubber one...
does not have any cables.The linkage is made out of rod and heim ends
I have a '71 cj5 with a 225 odd fire engine. I have rebuilt the engine and put a new clutch in it. I have driven it approx. 2400 miles since...
As most of the regulars on this site know..I have been fighting a hesitation under acceleration with my 71 Odd fire with a Roch. 2G the last...
I just install an hei and a tach (3 weeks ago) in my 71 odd fire. My tch had 4 wires... one for the the light in the tach, one goes to ground,...
thanks for the info. I have took the Carb back apart ..5th time.. and soaking it in cleaner until friday. I really think it is the Carb. I have...
I have a '71 cj5 with original steering box and shaft/worm gear. I put new seats in mine and had same problem. I was fine once I was in there but...
The timing marks are molded in the cover. The venturi cluster is clean. It shoots 2 nice streams when you give it throttle. This is the most...
That is where it is at....8 degrees btdc.
Thanks for the pic. That is where I have my number 1 at also. I took the small filter out of the fuel inlet on the Carb. but it didn't make a...
All great advise....thanks. I have been out of town so I have not been able to post in a few days (no lap top..spent money on jeep instead) Just...
I solved the idleing problem by removing the base plate of the Carb. (Roch. 2G) and removing the idle mixture screws and cleaning everything real...
I have finally got my 225 to idle..about 650 rpm. Starts right up when you hit the key. HEI is timed at 10 btdc. Problem I have know is.. it...
I remember replacing the check balls ...I think?.. Not a bad idea starting over with Carb. Thanks for all the advise guys.
k... I took my old pcv valve to the auto parts store and just kinda matched it up with one there. Is there a difference in them do you know? And...
not sure what is up with the smiley face..i didn't put it in there. Should say 1 7/8
Separate names with a comma.