Wow, got off the phone today with the folks at Rain Gear. Real nice lady, unfortunately they do not ship to Canada. Kind of shocking this day and...
Iam looking for help to mount a windshield to fiberglass tub, mostly the hole positions. I have assembled the original hinge on the original...
Many thanks to all for the advise that I have asked for and for the stuff I have found on this site. Steering and hydraulic clutch bracket...
Installed hydraulics on my clutch. Replaced the pressure plate and clutch plate, along with a new fork and throw out bearing. Wilwood cylinders...
I am transplanting a 1983 brake system into my CJ5. There are two ports on the assist as you see from the photo. The cj5's brakes currently in the...
I am looking for some photos or ideas for a battery tray for a 71 cj5 with a 225 in it. It has a fiberglass body and I did not think just tagging...
I have weeded through a couple hundred posts on this subject as Iam getting ready to go in one direction or another. There is a ton of pros to...
Installed the fork to night. Read about an hour worth info here on the subject and still have one question. How much free movement in the fork...
I have a buddy that has four 5-178X spicer U joints he is willing to part with. Has anyone used these with the stock drive-train in a 66-71 CJ-5?...
Good Morning Would anyone happen to have a drawing of an engine lift bracket, the one that uses the bolt holes from the carb? Is this the best...
I have a radiator out of a 84 CJ7 that had a 2.5L in it and I am wondering if the inlet and outlets are changed over do you think it will cool the...
Just assembling the rebuilt Tcase D18 to the tranny T14, there is bearing at the back of the tranny that seats between the tcase and tranny. This...
Got a problem, I have been trying to seperate the T90 from D18. Got the rear cover off, cotter pin removed, tranny and Tcase braced and breaker...
Just got the frame down to the stamp ID numbers tonite, if I am reading and converting correctly I am getting 1966. Is this correct? The numbers...
Has anyone ever tried to put a 5/8" to 3/4" thick adapter plate between a T90 and the T14 bellhousing bolted to a 225? Just starting to measure...
Just getting ready to purchase a set of frame motor mount brackets from Novak or AA and just wondering are there any other options? Anyone ever...
Does anyone have a part number and manufacture or source for valve cover grommet. The one for the oil breather. I have looked on most of the main...
I am looking to comfirm some angles on the valves, valve seats and heads on a V6 225. Valve seat angles, I am getting 45 degrees, Valve shaft...
I have been pokin around the net looking for an online suppier for speed parts for the 225. Who supplies this stuff? Anyone have any web sites for...
Separate names with a comma.