Just for those that may be interested, these folks have covers and parts. I am giving them a whirl. http://www.beachwoodcanvas.com/
Wow, got off the phone today with the folks at Rain Gear. Real nice lady, unfortunately they do not ship to Canada. Kind of shocking this day and...
Wow Bob, that's a big difference to here in Ontario. Two buddies of mine each have one of these engine in their possession and can't give them...
Good tip on the angle iron. I'll need to wait on the seal to get here and try your WS method. Sounds like it should it should go smoothly. Thanks
70's Cherokee wheelbase 109" ECJ5 wheelbase 80.5" Got some wiggling to do to make that fit. Maybe a post 1972 CJ6 or 8 would cover it at...
Check out this link, a good reference site. http://www.novak-adapt.com/knowledge/mopar_small_block.htm
Ordered the new one from here. http://www.twistedsteel4x4.com/index.php?main_page=product_info&products_id=206 $4.79 :) We'll see what it...
I think this will cover it! http://www.earlycj5.com/forums/showthread.php?t=31713&highlight=raingear
Thanks Adam After looking at couple websites that sell these seals they are different for sure. I have two CJ7 seals, the one has been cut off to...
Iam looking for help to mount a windshield to fiberglass tub, mostly the hole positions. I have assembled the original hinge on the original...
I went stock for under $100. Got it from Fort Wayne clutch, a great bunch and very helpful. Had it here in under a week! Check-em out....
I agree, had a 258 in my YJ. The carb sucked, but we installed EFI and it was a dream. Enough power for 32's on a YJ and better mileage.
I know I got battery problem to start with. That will be 1st on the list along with some new cables. We think it maybe timing, back fired through...
Many thanks to all for the advise that I have asked for and for the stuff I have found on this site. Steering and hydraulic clutch bracket...
That's what I am thinking, :oops: , did not want to admit it to myself. Wonder how I can get a look with out pulling the engine.
Yes, I now have full stroke with the cylinders unhooked, I had a hard time getting the air out as well. Hooked up, I have about 1/16" clearance...
Installed hydraulics on my clutch. Replaced the pressure plate and clutch plate, along with a new fork and throw out bearing. Wilwood cylinders...
:toetap: After 8 am here, where are the pics? R)
Thank you to all for the advice & photos. Very helpful as usual. :beer:
If this is a built in check valve in the mc, mine has one like the one in this photo. Where does the line go that is hook onto this valve?
Separate names with a comma.