I bought a Fel-Pro Oil Pan Gasket locally for my F-head and it is a fiber type, about 1/16 inch thick. The last one I had purchased about 5 years...
I have removed the flywheel from my '62 F-head because I am replacing the clutch and want to have it resurfaced before I reassemble. The manual...
I am about to remove the T-90 from my '62 CJ-5 and rebuild (slips out of 2nd gear). Does anyone know if the T-90 Rebuild Video is still...
I suspect this subject has been discussed here before so maybe someone can point me to a past posting. I searched and could not find anything....
I got the standoffs from Midwest Military - phone (952) 440-8778. They come as a kit. You have to paint them and attach the webbing with...
I recently obtained a pair of windshield hood rests that mount over the wipers on my '62 CJ-5. I have the footmans loop on the hood to tie the...
I have finally gotten my '62 CJ-5 to the point that I am thinking about "body parts" (kind of nice not to be laying underneath it for a change)....
The PO had pulled my '62 CJ-5 out of trouble by hooking onto the bumper. As shown in the attached photo, besides putting a crimp in the bumper,...
Here's a source for fuel pump rebuild kits: Antique Auto Parts Cellar (781) 335-1579 http://www.then-now.com/The_Cellar/cellar.htm The...
I need a new fuel pump for my '62 F-134 (no fuel pressure out). Are the ones like Krage sells quality pumps or is there something better out...
My '62 CJ5 has a Dana 44 with tapered axles. What size is that axle nut? I've had it off for a while for rehab work but I think I took it off...
Thanks for the ideas so far but I have checked the type of sources suggested and all I have found are the "normal" type grommets. The ones for...
I'm putting a new wiring harness in my '62 CJ5 and since I had the dash off I also removed the heater and did some refurbishing. I have three...
I wanted to get the fuel gauge on my '62 CJ-5 working. I determined that it was the sender so I removed the driver's seat and the sender. I have...
If you are going with the Pertronix unit, call them and ask for technical help. (800) 827-3758. The P/N label on my distributer is missing and...
I am going to get a fresh coat of paint on my '62 CJ5 - hopefully next Spring. In the meantime, I want to prep it and do some body work -...
Hippo393, You asked where I finally located a hub puller. I just called all the rental places I could find in my area and as it usually happens...
When I pulled the hubs off my tappered axles I went through what a lot of people have probably gone through. It was tough, real tough. I finally...
Russell, Thanks for the thread - the E-bay photos were helpful. The bracket you mounted your valve to originally had a loop in the end to hold...
John, My controls consist of three knobs under the dash, each attached to a bowden cable. One is for the flap in the heater box, one for the...
Separate names with a comma.