No I didnt get a rebuild kit for it, the gaskets and pumps were all in good condition so I was just cleaning the jets. When its running the...
Yeahh I did do that, but still cant find any information on the float levels or anything...
this carb doesnt look like the weber 34 dcoe at all....
I am having no luck with finding info on weber 34. I have tried weber's site, other 4wd sites, google. I cant find any diagrams, specs, settings,...
I had a Weber carb given to me to put on my '74 CJ5 with the 258, to get rid of the old bbd. The carb came on the intake of a jeep 258 intake, so...
Figured it out!! I moved the slave downward, I didnt see one of the holes lower, it was covered in grease. So now the slave is back in line with...
Yeahh!! thats what I was thinking too. I never gave it a thought before I put it on, but fuel line is designed for the high pressures.
Yeah I am using an adjustable one too. I am also using rubber fuel line.... could this be the problem? suppose the rubber is expanding instead of...
Update: When I have no slack at all on the slave linkage, (if anything, I have some pressure on it), the slave piston moves a very very little...
Okay, yeah I am just under bottoming out the master piston. I have bled it and bled it and bled it :-/ used almost 1/2 gallon of DOT 3
Yeah I have read the Novak site on the clutches. I have bled the system, multiple times. It is about 90 degrees, I had to do some fabrication to...
I got a slave and master cylinder for a 1980 cj5 with the 2.5 L engine in it, because many of the people that have put a hydro clutch on a mid...
If I got a new slave from a 1980 CJ5 with a 2.5L, Can I get just about any master? Should the bore size be the same, or does it matter?
Yeah!! It seems everyone that has gone with the hydro clutch install say it is the best mod they have done. Those of you that have put a hydro...
I can take a look at the linkage. Just after reading that everyone else has had such problems, I figure I am just in the same group. Mine only...
Every Single time I take it out, I either A) Have to adjust the clutch from when the jeep torques it rides the pressure plate, B) Have the linkage...
How far down the pedal did you drill. Any pictures of that?
I have a 74 cj5.....and...anyone who has one around the same era knows... the clutch linkage SUCKS! so, I am going to bite the bullet and put a...
Thanks for the information!!!! Very helpfull. I knew the PSI shouldn't have quitte so much varience. Yeah, I never really beat on the jeep...
I have a 1974 CJ-5 with a 258 inline 6 engine in it. Speedometer says 97,980 miles, but I am not sure that it ha the original engine. I have a...
Separate names with a comma.