I think your bearing is attached to the shaft: [ATTACH]
I have the Oil Scoops. Just removed them for the photos.
I was comparing 2 overdrives side by side and I noticed that one of them has a bearing in the center and the other does not. [ATTACH] The other...
I took a couple of short videos of my engine running with a vacuum gauge attached. Here it is at idle (about 700 rpm): [MEDIA] And here it is...
Far from being frustrated, I'm happy it broke in my hands instead of after I installed it.
I found my wayward LUK fork. Here are some photos to compare it to my rusty replacement fork: [ATTACH][ATTACH][ATTACH] The metal frame looks...
For reference, here is a single stick: [ATTACH] And here is a twin stick: [ATTACH] The twin stick is a lot shorter.
I also have the Speedhut gauges. I installed them 1 year ago and so far they are great. If you don't need original gauges then I highly...
jeepdaddy2000, I did remove the front bearing retainer, and that did allow the gears to separate a little bit. It's possible the bearings are...
[ATTACH]
My CJ6 has an SM420 transmission that has been shifting poorly. I pulled the transmission and found a bit of wear on one of the synchros. I'm...
I have an SM420 in my CJ6. Oil was dripping from the bell housing and the advice I got was that the rear main seal was leaking. After some testing...
Separate names with a comma.