1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by Jmoto

  1. Jmoto
    Post

    got brake and rear turn signals but no tail lights

    Do you have 1157 bulbs? Silly things I over look all the time.
    Post by: Jmoto, May 26, 2014 in forum: Early CJ5 and CJ6 Tech
  2. Jmoto
    Post

    Runs terrible, idle is fine, no power and just breaks up. f-134 timing problem?

    I had similar issues with mine when I first got it running. Not as bad as yours seems. Originally rebuilt the carburetor with a generic kit....
    Post by: Jmoto, May 4, 2014 in forum: Early CJ5 and CJ6 Tech
  3. Jmoto
    Post

    fuel pump question

    Well I asked around and this is what I was told. You should not put a fuel filter before the pump. There is always a small amount of air trapped...
    Post by: Jmoto, Apr 28, 2014 in forum: Early CJ5 and CJ6 Tech
  4. Jmoto
    Thread

    fuel pump question

    I have a '61 CJ-5 rebuilt to mostly original specs. Rebuilt 134 engine, rebuilt carburetor, and a rebuilt fuel pump. A few weeks ago I took the...
    Thread by: Jmoto, Apr 26, 2014, 7 replies, in forum: Early CJ5 and CJ6 Tech
  5. Jmoto
    Post

    Measurement request

    I come up with 25 9/16"
    Post by: Jmoto, Nov 11, 2013 in forum: Early CJ5 and CJ6 Tech
  6. Jmoto
    Post

    Opinions of rust removal from chassis

    I did this my frame. Here's a link http://www.earlycj5.net/forums/showthread.php?93489-Electrolysis&highlight=electrolysis post #21 has a link to...
    Post by: Jmoto, Sep 27, 2013 in forum: Early CJ5 and CJ6 Tech
  7. Jmoto
    Post

    how much is too much?

    If it"s going to be a daily driver and you don't care about a restoration job, fiberglass might be your best bet. Salt water, salt air, and salt...
    Post by: Jmoto, Apr 14, 2013 in forum: Builds and Fabricators Forum
  8. Jmoto
    Post

    First Jeep build! Here we go...

    I had to ground the sending unit to get mine working.
    Post by: Jmoto, Jan 6, 2013 in forum: Builds and Fabricators Forum
  9. Jmoto
    Post

    Show Us Your Jeep!

    After four and a half years finally got it out of the garage. Still far from finished, but it started, drove down the road, and stopped. 2008...
    Post by: Jmoto, Dec 16, 2012 in forum: Builds and Fabricators Forum
  10. Jmoto
    Post

    making my 5 a 6

    Hello Kitty. Lookin' good. Is the tailgate area narrowed? I kinda like it tweaked in like that.
    Post by: Jmoto, Dec 1, 2012 in forum: Builds and Fabricators Forum
  11. Jmoto
    Post

    won't Start

    Couldn't get mine to start. After 30 minutes of head scratching someone suggested to check the firing order. Of course I had that right. Wrong....
    Post by: Jmoto, Apr 7, 2012 in forum: Early CJ5 and CJ6 Tech
  12. Jmoto
    Post

    Starting F-head after rebuild, a few questions, before I do this.

    here'd how I wired mine. [IMG] red wire went to battery positive to ballast resistor. yellow wire from ballast resistor to coil positive. light...
    Post by: Jmoto, Mar 31, 2012 in forum: Early CJ5 and CJ6 Tech
  13. Jmoto
    Post

    fiberglass body

    I'm in the process of mocking mine up now. I currently cut one inch blocks of wood to rest the body on the mounts. I want the body to sit as...
    Post by: Jmoto, Mar 21, 2012 in forum: Intermediate CJ-5/6/7/8
  14. Jmoto
    Post

    Mounted the spare tire, does this look right?

    you might want to consider a large thick washer on the two bolts going through the hat channel. Something that will distribute the load out to...
    Post by: Jmoto, Mar 18, 2012 in forum: Early CJ5 and CJ6 Tech
New Posts