it's sad that it has taken me so long to find time to torque my pinion yoke, oh well. i torqued it to 215 ft lbs with a 3" extension and i still...
it only took a block of wood in front and back of the rear wheel and a 1/2 inch ratchet to get it off, and i didn't have to work at it that much....
my pinion yoke has pieces broke off of it, there i one on ebay for 33.00 plus shipping is this a decent price? it's new. also what should the nut...
i just put the same set up as you have, minus the extreme, i put on an older flowmaster i had in my garage. i don't really like the rapping sound...
yes, that is what i am talking about i'm thinking it might even be a bad u-joint it is making kind of a clunking sound when i take off. i guess...
shouldn't i be able to see wear marks? i am gonna replace the rear joints so i will check to make sure the yoke is tight first and go from there i...
i have play in my rear end when i turn it side to side, like before the gears engage or mesh together. do i need to add shims or what? i took the...
how does it sound with the single flow master behind the 225? is it better performance with a single exhaust?
do you have a good part # for the fuel pump? who stocks it or can get it?
i'll take a look, thanks.
i just put some new leaf springs and 33" tires on my jeep and they are cambered quite a bit. how do i correct this? 67 cj5 dana 27.
i got it on.R)
just an update on my top progress, was putting the bows and stuff in and of the vertical rails by where the door strike is at is 1 1/4" shorter...
Separate names with a comma.
