That would be AWESOME! Shoot me a PM if u run across them. Thanks!
Anybody know where I can pick these up. I know the factory originals wear out fairly easily. Thanks
It cost $500 for the frame, seat brackets, and alot of misc. parts off the jeep. And I am seeing the littl;e rust bubbles coming through in open...
Could u post some pics of the crossmember set up? I'm having problems getting my engine to sit on the crossmember right. It is about 3 inches...
I took it to a shop. They said they blast before they coat but obviously i didn't stand there and watch to make sure. The frame looks smooth but...
I had the frame of my cj5 powder coated a little over a year ago and it's aready got rust coming through. It's a rolling chassis. I don't know if...
Anyone have pics of the crossmember on a 72? I'm having problems get my set up to "jive".
Are there any companys that reproduce the factory vin plates that are attached to the frewall in the engine compartment?
Here's what I've seen. Green '76, CJ7 style doors, fixed hard top with a large single door in the rear with "Jeep" stamped in it, sliding doors,...
If you could cut them above to include the seam and e few inches into the firewall potion were the fenders bolt on it would be VERY much...
Separate names with a comma.
