That would be wonderful, I'll send you a PM.
Hello all, The turn signals were acting up in my 75 CJ5. Did some searching and decided to disassemble and clean out the Sparton turn signal and...
sparton ts
That jeep up here would be at least a $3500 rig, if not more. No cancer with original paint is unheard of in the NW. But if it's not what you want...
I definitely married a keeper. Pickles is a great an unique name. :) I'm going to have to take the just drive it advise and hopefully a great name...
My wife likes my CJ5 so much that she had to have one too. After a fair amount of unsuccessful searching we took a break from the hunt. While...
My 75 had the tank set up under the seat and I took it out. x2 on the fuel smell plus it stuck out about 6 inches past the seat on the floor...
Went through this conversion 6 years ago. I picked up a donor 82' Dana 30 with the 2 bolt caliper set up. I took the knuckles and calipers off of...
For the roller bearing. Check applied industrial technologies. They have been able to get all kinds of odd bearings that I've needed in the past.
Mr. Gasket makes a good header gasket for the 304. Definitely follow the advise of Thorwon, Check the header to make sure the surface is still...
Is it a replacement from crown? I had the same issues and ended up returning it and fixing the one that was in my tank. :(
I bought a Crown OEM replacement for 75. It worked so-so and it burn out after a couple of wheeling trips. But I have bad luck with anything...
I'd check the bearing sizes inside the bearing hub. They might be different. I know that they were when I did my swap.
Separate names with a comma.