Check out “metalshapers” t90 rebuild on YouTube
He uses a “sealed bearing” ( inside seal removed) to prevent this from happening. I believe...
Lent mine out, hasn’t come back yet
DOT approved. Other suppliers are available, Walcks is just one.
Check out “metalshapers” video on rebuilding these on yt.
He uses this on threads. [ATTACH]
If you decide to go with new lift kit springs, the front will sit lower than the rear. Due to the shackle mounting position in the frame as...
You might want to post up some pics of what you have and application....
I have the same factory set up in my 6.
There was some discussion in past on this issue on the early 5’s and 6’s. Some actually preferred this...
[ATTACH] Warn used to make a kit to accomplish this, no longer made. Herm the overdrive guy sells a kit and or parts. Others here have rolled...
I can only speak from personal experience. Dana 25, bendix joint with the same issue. The spicer shaft fit right in without issue.
IIRC metalshaper addressed this in one of his videos.
Steering mod? A little cutting behind the shift tower? Looks good.
I have run a Napa 3031 fuel filter between the tank and pump on my f head for years, along with a pressure regulator between the pump and carb,...
Separate names with a comma.