Have you measured the length of your old pump and diameter of the new pump cup? If you have a harbor freight around you can buy a digital caliper...
OR you could check out the JCCA site... I feel vindicated now Pack Rat:)
If your Jeepster is stock, your front axle is a D27. D30s with drums came in '72. It seems most guys ditch the two piece front driveshaft and go...
The pump in the Walker kit is okay, but I've had the cup fold on me twice. The best ones you can get currently have the spring under the cup. I...
I've sold 2 Jeepsters recently, a '70 and '71. Both ran. That one looks like it has pretty decent floors, but as was stated previously, not...
Doh! Yep. 67-69 in the description.
Partsdude sells them, $17 ea http://stores.partsdude4x4.net/lens-park-signal-lens-amber/
I have a Perkins P4 in the garage and have been doing some research on the engine. As far as I can tell the P4, 4.192, and 4.203 are the same...
Andrew--Where are you located? It doesn't say in your profile.
Update. Bought a 4 pack of assorted small springs at Home Depot. 20 min with a couple needle nose pliers and a diagonal wire cutter = problem...
Okay, so now I've had two carbs with a similar problem -- rubber skirt that came with the rebuild kit pulls away from the pump body, so no squirt....
Thanks Pack Rat. It's the driver's side door, but I think the spring will fit either side.
Yep. That's the spring I'm looking for.
I need the coil spring the goes from the pawl in the door latch to the shaft connected to the latch cam. This is the spring the pops the cam to...
Separate names with a comma.