I don't have any experience with the AA kit but I remember how detailed and easy to follow the Novak instructions were when I did my t-case a few...
Really nice work. I found & read your whole thread last night. I am sooo impressed with your fab work. I have recently picked up working on my...
Thanks for the feedback everyone. I feel better knowing there knowing there are rigs running around with the drive train offset like mine is...
Thanks for the pics. I took some pics of my mounts. The motor mounts in both of your jeeps do appear to be the same size and most likely you have...
Thanks for the pic Maverick. Your mounts look more or less equal in size. Is that correct? My mounts are different. My driver side mount is...
No thoughts anyone?
I have the cable on my '70 cj5 and haven't had any problems. I think I would have to cut a slot in the clutch fork to connect the cable to it....
I am installing a 304 v8 in a '72 renegade and would like to know which clutch linkage set up is better. The '72s from what I read used the cable...
I will try to keep this short & sweet. :roll: I picked up a rolling '72 renegade with a good body, frame and axles (D30 / D44) with no engine &...
I have never read of this possibility. The first thing that comes to my mind about mating your D18 to a sm420 without adapter is the 420 does not...
X2 on lots of sealant on the front & rear output shafts & yokes. I also used copper gasket sealant sprayed on each side of each well cleaned...
Thanks for the replies. After looking at at the pin clearance, it will be best to pull the carrier out - got to love more work. So are all...
I have a '72 intermediate tracloc 30 spline, 4.27 gearing, rear axle with a chipped tooth on one of the spider gears. Can I replace it with any...
Separate names with a comma.