Thanks, I didn't buy a kit, I bought the pressure plate and disc at NAPA years ago. This project got started and then put on hold for a divorce...
Does anyone know of a good source / part number for a clutch alignment tool for a T14 - 225? I don't have an extra input shaft. Any ideas will...
Thank you, we thought it would but wanted to check.
Will the adapter on a two piece bell housing from a T86 bolt up to a T14 or will the adapter need to be replaced?
I don't need a flywheel, only the bell housing. I have talked to another person with a bell housing in your part of the country, I believe...
Very helpful guys. sounds like the BDS route will most be the way I will go.
Thanks for the replies. I looked at the website; good write up and looks like a nice kit. I had decided to go with the BDS 2.5' lift spring kit...
I assume this has been covered before, but I couldn't find it in a thread search. What mods are required for an ECJ5 ('71) conversion to YJ...
Thank you
I have a 1971 CJ5 with a 225 and a T14. The transmission is out and over the years the bell housing has gotten lost. I've found one on the...
How about some small safety pins; I use them to push through a wire as a test point for my meter.
Separate names with a comma.