Thanks Jim, that clears it up for me and the fix as well. Thanks much!!
That's possible, but what has me stumped is that the inner grease seal is 2 7/8" OD instead of the correct 3" OD, suggesting a different drum....
OOPs! But That's how my fingers are labeled...:) :) :) If the race is fully set then I guess i'll just leave the clip off. Thanks!
Ok, here's some more info. The problem is with the right front. I just finished the left front. (It's nice to work 4-10 hour days so I can spend...
Re: Axle C-clip.... "what the hey?" Thanks for the response Tim. I forgot to mention that I did try the screwdriver routine but used a bolt...
Hi and thanks ahead of time. Front end is a D27. Ok here's the problem: After replacing my spindle and bushing I am not able to install the...
Thanks for the info Matt, I tried just freezing the Bushing but it still didn't seem to be enough, although I didn't try "wacking" it. I'll go put...
I know I've read this somewhere but not able to find it in the archive. But I assume I heat the spindle and cool the bushing to get them...
The following link has a nice electrical chart with Conservative curent values per wire size. Below the chart is a nice "calculator" that one...
DJ Frame to Cj conversion During my recent adventure to the Jeep Salvage Yard, a DJ frame caught my eye. It had been in the process of being...
Separate names with a comma.
