Sorry for repeating what you said...your post wasn't showing on my phone when I add my $0.02.
The crossmember needs to twist when the frame does. If it's too stiff there'll be greater stress where it meets the frame rails and more likely to...
I think the sliding gear is splined.
Like this...
That's facet-nating! :clap:
Good enough reason. (y) I was afraid you were pulling off some super-neat trick and I was missing it. :sleep:
Why the "pie slice" in the middle? Just curious.
I remember a bridge like that across the Mulberry River in NW Arkansas when I was a kid...the diagonal braces would start whipping when we drove...
Industrial Origami?
Old Van Gogh was ahead of his time. :rofl:
I think the easiest way to upgrade the steering in an early Jeep is to get everything from steering box to steering wheel from an intermediate...
.004"-.008" comes to my mind...could be wrong. Try to keep the clearance to low side during setup. Put a THIN coat of sealer between shims to...
Going with a Saginaw box (already mounted). Steering shaft can be seen in the pic.
11" brakes and MC from an intermediate bolted up (without modification) to a V6 MC mount on a 3A frame. Connected last 2 lines and bled. There's...
Last night, actually. I either plumbed the MC to bench bleed...or I developed a new kind of still.[ATTACH]
Separate names with a comma.
