1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Wilwood Hydraulic Clutch Setup For Thru Floor Pedals

Discussion in 'Early CJ5 and CJ6 Tech' started by curtcanada, Oct 9, 2012.

  1. Oct 9, 2012
    curtcanada

    curtcanada L, L, and the POH!

    Western Slope, CO
    Joined:
    Nov 25, 2008
    Messages:
    372
    Here are the pics I took of a project that had this set up. It was on a 1971 CJ-5 with 225/t18/d18 engine-driveline. Also, this had stock exhaust manifolds and exhaust routing. I have fenderwall headers that will probably cause issues with the mounting of the master cylinder, when the time comes.

    Pic#1 and 2 show the "master cylinder" linked to the clutch pedal.

    Pic#3 is the hydraulic line going to the slave cylinder.

    Pic#4 and 5 show the pull-type slave cylinder, and how they bracketed it. Note the thickness of the brackets. Even they were flexing a little, when the clutch pedal was pushed.

    Pic#6 and 7 are looking at the slave cylinder, from below, showing the hydraulic connection and brackets used.

    Pic#8 is showing the cable off of the slave to the pivot on the bellhousing.






    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]
     
    curtcanada, Oct 9, 2012
    #1
  2. Oct 10, 2012
    Freefree

    Freefree Member

    Hanover, MA
    Joined:
    Oct 21, 2011
    Messages:
    59
    That is exactly what I am looking to do. Thanks for posting the pics.
     
    Freefree, Oct 10, 2012
    #2
New Posts