1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

DIY Free Floater

Discussion in 'Early CJ5 and CJ6 Tech' started by Agent454, Mar 14, 2009.

  1. Mar 14, 2009
    Agent454

    Agent454 New Member

    Litchfield Park...
    Joined:
    Dec 17, 2008
    Messages:
    33
    While searching the Tech Library about a FF kit, I ran across the DIY thread. I was able to pick up a D27A & D44 for next to nothing. Machining the spindles to fit the D44 is no problem.
    Big question is the bore of the D27 spindles. Does R&P or Herm or anybody else, sell axle shafts with that 19 spline & 27 spline for this application? Or should I try to find someone to make them as the thread shows? If they do, will I need to bore the spindles?:?
     
    Agent454, Mar 14, 2009
    #1
  2. Mar 14, 2009
    Warloch

    Warloch Did you say Flattie??? Staff Member

    Falcon, CO
    Joined:
    Mar 4, 2003
    Messages:
    5,470
    Check with Herm - he has a couple different sets of axle shafts that might work, or be able to give you some good ideas.
     
    Warloch, Mar 14, 2009
    #2
  3. Mar 16, 2009
    nickmil

    nickmil In mothballs.

    Happy Valley, OR
    Joined:
    Sep 23, 2002
    Messages:
    12,529
    Herm is selling them. R&P was but the cost was too high to compete so they are now selling Herm's kit.
     
    nickmil, Mar 16, 2009
    #3
New Posts