1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

After market oil pressure guage

Discussion in 'Early CJ5 and CJ6 Tech' started by Smokie, Jun 5, 2008.

  1. Jun 5, 2008
    Smokie

    Smokie Member

    Rolla MO
    Joined:
    May 27, 2008
    Messages:
    53
    It's me again Margaret! I have searched all threads on this subject and no clear answers to me. Where do you hook into an oil line on a F134 for a mechanical oil pressure guage? I cannot find a factory sender so maybe the PO butchered it too. Maybe a pic would help?
     
    Smokie, Jun 5, 2008
    #1
  2. Jun 5, 2008
    SIDSCJ

    SIDSCJ Jeep addict

    14th State
    Joined:
    Jun 25, 2004
    Messages:
    1,192
    Drivers side, towards the rear. There's a tapped hole just below the supply line that goes up to the head. Usually has the sending unit screwed into it, use a Tee fitting if you want to run both the gauge and the lamp in the speedo.HTH
     
    SIDSCJ, Jun 5, 2008
    #2
  3. Jun 5, 2008
    Homebrew2

    Homebrew2 Member

    Dunlap, CA
    Joined:
    Aug 17, 2007
    Messages:
    511
    There should be another port in the block just below the port that feeds the head via tubing @ rear driver's side of engine.
     
    Homebrew2, Jun 5, 2008
    #3
  4. Jun 5, 2008
    Smokie

    Smokie Member

    Rolla MO
    Joined:
    May 27, 2008
    Messages:
    53
    I know the one you're talkin about. thanks guys.
     
    Smokie, Jun 5, 2008
    #4
  5. Jun 5, 2008
    Smokie

    Smokie Member

    Rolla MO
    Joined:
    May 27, 2008
    Messages:
    53
    Found the factory sending unit. It was covered in two feet of grime with no wire on it. Im gonna remove it and put in mechanical guage line.
     
    Smokie, Jun 5, 2008
    #5
New Posts