1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Spring plate ?

Discussion in 'Early CJ5 and CJ6 Tech' started by Huntman, Oct 5, 2007.

  1. Huntman

    Huntman HIGH ROLLER

    will the stock spring plates work with d30 u-bolts or should i get new plates?
     
    Huntman, Oct 5, 2007
    #1
  2. Warloch

    Warloch Did you say Flattie??? Staff Member

    Stock D27/25 are narrower than the D30. Some folks open them up - I got new D30's with dual pins so I could keep the shock in the right place.
     
    Warloch, Oct 5, 2007
    #2
  3. jeep67

    jeep67 Member

    If you have the time and money, I would do what worlock did and order an aftermarket setup with double shock mounts (preferred method). Or, if you are in a pinch and need to get the jeep on the road, you can re-use the stock ones but you will need to do a little filing and will need to bend the u bolts slightly in to get them to work. I used a large C clamp to bend the u bolts in just enough to allow the stock spring plate to slide over.
     
    jeep67, Oct 6, 2007
    #3
  4. Huntman

    Huntman HIGH ROLLER

    ok thnaks guys. Chuck where did you get your plates at with the dual pins? may just order them i have to get new u-bolts anyway.
     
    Huntman, Oct 6, 2007
    #4
  5. Warloch

    Warloch Did you say Flattie??? Staff Member

    They are on the Rocky Mountain Suspension Page - Number 2402 at the bottom of the page (pretty sure that's the one I used, but can not find my sheet).
     
    Warloch, Oct 6, 2007
    #5
  6. Huntman

    Huntman HIGH ROLLER

    ok thanks, i look later when i get some time and find them. thanks again!!
     
    Huntman, Oct 7, 2007
    #6