1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

convert T90 clutch linkage to hydraulic?

Discussion in 'Flat Fender Tech' started by metal_miner, May 27, 2007.

  1. May 27, 2007
    metal_miner

    metal_miner New Member

    Elko, NV
    Joined:
    May 20, 2007
    Messages:
    26
    Has anyone converted the T90 mechanical clutch linkage to hydraulic?

    If so what was the best way / parts to do it? I'm looking to do a swing pedal conversion, but was debating on if I should just do the brake or do both the clutch and brake pedals.

    -Thanks
     
    metal_miner, May 27, 2007
    #1
  2. May 28, 2007
    Posimoto

    Posimoto Hopeless JEEP Addict

    Minden, Nevada
    Joined:
    Aug 7, 2003
    Messages:
    4,540
    Posimoto, May 28, 2007
    #2
  3. May 28, 2007
    metal_miner

    metal_miner New Member

    Elko, NV
    Joined:
    May 20, 2007
    Messages:
    26
    Thanks for the link...

    Is the slave in one of the pics you posted only secured at the clutch fork end as well as at the heim joint, i.e., no other support in the middle of the slave to tie it to your fabbed bracket?
     
    metal_miner, May 28, 2007
    #3
  4. May 28, 2007
    Hansh

    Hansh Going Mobile

    SE Wisconsin
    Joined:
    Dec 7, 2004
    Messages:
    425
    I used the Novak kit for the brackets and slave cylinder. The master is a 3/4" bore from a Wrangler. My pedals are from an intermediate Jeep. I have a t86 3 speed, but should be close to the same.
     
    Hansh, May 28, 2007
    #4
New Posts