1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Part number for the factory rubber transmission mount for the T98

Discussion in 'Early CJ5 and CJ6 Tech' started by uglyjeep, Nov 17, 2006.

  1. Nov 17, 2006
    uglyjeep

    uglyjeep Member

    Joined:
    Oct 9, 2005
    Messages:
    61
    Hi everyone,
    Does anyone know what the factory part number for the rubber mount between the transmission crossmember and the factory t98 transmission adapter is for a late 60s cj-5? I am assuming it is different than the 3 speed vesions...

    Thanks in advance!
     
    uglyjeep, Nov 17, 2006
    #1
  2. Nov 17, 2006
    jpflat2a

    jpflat2a what's that noise?

    Hermosa, SD
    Joined:
    Jul 30, 2003
    Messages:
    8,525
    my book shows 912721
    that number could have been superceded by now though
    FYI
     
    jpflat2a, Nov 17, 2006
    #2
  3. Nov 20, 2006
    lynn

    lynn Time machine / Early CJ5 HR Rep Staff Member

    Huntingdon PA
    Joined:
    Sep 20, 2002
    Messages:
    3,437
    The T18 installed in my CJ uses a Jeep T98 "Texas" adapter between the tranny and D18 tcase. The rubber mount, about 6" long, bolts to that adapter, and to the crossmember. Mine uses the same mount that is used for the T14 in the V6 rigs, p/n 939995. Should be available from places like Krage and 4WDH using this p/n. Cost should be under $15.
    I did need to use a round file to slightly elongate two holes on this mount to get it to fit the T98 adapter. Probably 1/4" on each hole, literally 10 minutes or less.
    HTH!
     
    lynn, Nov 20, 2006
    #3
New Posts