Speedo assembly question

I just got a new speedo assembly, mainly because my temp gauge was no longer functioning properly, but also to have an updated gauge set. The Temp side is opposite of stock, meaning the H and C are on the other side. As well as the F and E on the gas gauge. Will I have to change the wires over to the other terminals or just swap them as is. Anyone ran into this issue????

How about the light bulbs in there. I plan to replace them all while I'm at it. Are they readily available at your friendly auto parts store???

Thanks

High5

 

the terminals on the guages should be labeled (I, S, A) just make sure they are to the same one they were on the old guage.

Fuel guage:
S=sender (sender wire)
A=regulator (metal strap to temp guage) (mine has a wire for lights connected here)
I=ingnition (12v in)

temp Guage:
A= regulator (metal strap from fuel guage)
S=Sender (sender wire)

Note: the labels for the wires may not be visible with them mounted in the Speedometer.

 

Thanks,

Now I just need some time to tear it apart.

High5