dana 44

will 30 spline spider gears and axel shafts fit in a 19 spline dana 44 rear (jeep cj5)

 

Nope, they are a different size as I recall.

Jim

 

if you want to go to 30 spline you will need the loaded carrier, carrier & lunchbox locker, limited slip, or full case locker; "adapter" carrier bearings; and shafts.

 

Is it center set or off set?

 

its an offset sounds like i have to change the carrier and bearings where does the adapter go and will 5.38 gears fit

 

no adapter, that's why it's in quotes. i was refering to the bearings themselves. i can't remember the part number off-hand, let me do some searching. gears should swap over np. as far as shafts, using flanged or going custom?

 

I think you have to go custom. I have not heard of 30 spline flange axles for the off set 44. Could be hard to find. Next best thing is a full floater kit.

 

Look for a 70-71 axle. Mine bolted right in place of the tapered.

 

X2

 

thanks im going to lookfor a 30 spline axel or maybe a floater kit with a locker