Dana 20 T-case Torque Specs

I stink at searching the web, so maybe some of you guys already have the answer?

I am getting a new driveshaft from Tom Wood, and I gave him all the info he needs to make me a new one except the spline count to the t-case. ( I guess he wants to give me a new yoke?)

In order to get this spline count, I need to take off the old yoke, slip it out a little and count the splines... right? How much torque is needed to put the yoke back? I need to drive this Jeep while this driveshaft is being made and shipped to me. I assume the torque setting will be the same for the original and the one I get from Tom, right?

Thanks,
Brian

 

The reason for the new yoke is he probably making you a a cv style driveshaft. You have to use a CV style yoke.


Install new output yoke oil seals and install yokes. Torque to 175 ft. lbs.

Check unit for freedom in all modes by hand turning.

 

Yes, he going to make me a cv driveshaft.

Thank you very much for the reply.