Wiper motor mounting bracket

Here's a bracket I made to install one of the cheap electric wiper motors above the windshield using the stock mounting holes. The material is 1/8 x 1 1/4 strap, but you could also use 1 or 1 1/2 strap. I also reused the old vacuum motor hose to run the wires in. The two flat washers shown go between the bracket and motor to act as spacers.

 

good job

 

Hmmm, interesting. I used a cut-off wheel on my Dremel to cut the shaft and the threaded outer down to length then mounted that to the stock holes. The extra mounting screw tab didn't line up with anything, but I was able to cinch it down plenty, so no biggie.

Your way looks more secure though....

 

I am unable to see picture of bracket. Could you resend it to me?

 

Considering this topic was posted seven years ago, this forum member may not even use the forum anymore!

 

I figured it was worth a try. Why try to design something when some one has already made it.