1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Basic Wiring To Start And Run An F134

Discussion in 'Early CJ5 and CJ6 Tech' started by matt johnson, Jul 12, 2021.

  1. Jul 12, 2021
    matt johnson

    matt johnson Caretaker of family Jeeps

    chesapeake, va
    Joined:
    Sep 3, 2003
    Messages:
    231
    Ok. So Ayden and I are headed to Alberta next week to work on the '67. New harness is in the future. For now just going to wire enough to run and move it. It has the generator. Can someone please provide us with the basic wire diagram to do this. Thanks.
     
    matt johnson, Jul 12, 2021
    #1
  2. Jul 12, 2021
    Howard Eisenhauer

    Howard Eisenhauer Administrator Staff Member

    Tantallon, Nova...
    Joined:
    Nov 22, 2003
    Messages:
    8,124
    If you're just running it around the yard don't worry about the genny. This is all you really need, yellow clip lead for the ignition, blue to start.

    upload_2021-7-12_22-52-19.png
     
    Howard Eisenhauer, Jul 12, 2021
    #2
    ojgrsoi, dozerjim, Ol Fogie and 5 others like this.
  3. Jul 13, 2021
    Twin2

    Twin2 not him 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Virginia Beach, VA
    Joined:
    Apr 28, 2011
    Messages:
    5,421
    the good old days . when you could hot wire a car
    used a screwdriver on starter solenoid
     
    Twin2, Jul 13, 2021
    #3
    Ol Fogie likes this.
  4. Jul 13, 2021
    matt johnson

    matt johnson Caretaker of family Jeeps

    chesapeake, va
    Joined:
    Sep 3, 2003
    Messages:
    231
     
    matt johnson, Jul 13, 2021
    #4
  5. Jul 13, 2021
    CJ Joe

    CJ Joe Truckhaven Tough!

    Pinon Hills, CA
    Joined:
    Nov 9, 2002
    Messages:
    390
    Why not bump start it? Then you only need one wire.
     
    CJ Joe, Jul 13, 2021
    #5
    matt johnson likes this.
  6. Jul 14, 2021
    elawson

    elawson New Member

    Joined:
    Nov 23, 2009
    Messages:
    23
    Unless you need to charge the battery from the running engine, leave both the generator and regulator "wire free".

    For whatever reason, whenever I connect the blue wire in the diagram...and the starter clunks and the engines beings to spin....I always jump, even though I want the clunk and spinning engine.

    The spark plug wires need to be connected, as does the small wire going between the coil and the distributor. Please don't ask why I mention this! :)

    Eric
     
    elawson, Jul 14, 2021
    #6
    matt johnson likes this.
  7. Jul 14, 2021
    matt johnson

    matt johnson Caretaker of family Jeeps

    chesapeake, va
    Joined:
    Sep 3, 2003
    Messages:
    231
     
    matt johnson, Jul 14, 2021
    #7
New Posts