Dana 30 questions

I'm piecing together a front end on the cheap & I've found a guy with inner axles to go with the housing I have. My question is does anyone have accurate measurements for the short & long side axles for a narrow track cj without the stubs? Just want to make sure it's a narrow & not a wide track set. Thanks for any help...

 

There are differences in the axle shaft stubs between drum and disk axle assemblies
Best narrow track Dana 30 iteration questions | Page 6 | EarlyCJ5.com
I don't have the measurements you're looking for though.

 

I think I still have a set of narrow track width axle shafts for a narrowed 44 kicking around. I'll look tonight or tomorrow if no one else posts up. Length will be close enough to a 30 to get you the length you need to verify narrow or wide track.

 

Better yet, a quick simple internet search and this popped up:

Front Axle Chart - Predator Front Axles

 

Thanks nickmil, that's exactly what I was looking for. The closest thing I found on my searching was the axle lengths of 22 7/8" for short side & 35 3/4" for the long side, those were posted on crowns Web page & those have to be the measurements for the inner & outer together.