1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Intermediate Shaft Replacement - D20

Discussion in 'Intermediate CJ-5/6/7/8' started by rossgn, Feb 3, 2013.

  1. Feb 3, 2013
    rossgn

    rossgn Member

    Joined:
    Aug 1, 2012
    Messages:
    60
    Is there a werbsite or link that will give the basic steps on replacing the intermediate shaft and bearings in a '72 CJ....I've got the Jeep Owners Bible and the Jeep CJ Rebuilders Manual, but not finding anything on replacing the shaft without removing the xfer case.

    Any help would be appreciated.

    Thanks

    Ross
     
    rossgn, Feb 3, 2013
    #1
  2. Feb 3, 2013
    sterlclan

    sterlclan Member 2024 Sponsor 2022 Sponsor

    exploring the...
    Joined:
    Feb 21, 2009
    Messages:
    3,899
    sterlclan, Feb 3, 2013
    #2
  3. Feb 3, 2013
    rossgn

    rossgn Member

    Joined:
    Aug 1, 2012
    Messages:
    60
    Perfect...thanks. Now if I can just figure out what to use to drive the shaft out
     
    rossgn, Feb 3, 2013
    #3
  4. Feb 3, 2013
    rossgn

    rossgn Member

    Joined:
    Aug 1, 2012
    Messages:
    60
    Laying underneath, couldn't get a solid whack to drive out the shaft. Broke out the air chisel and that drove it right out. Shaft and needle bearings all "look" good, so 'm not optimistic that this is going to be the source of my driveline noise. Since the replacement shaft and bearing kit is pretty cheap, just going to replace it anyway to be sure.
     
    rossgn, Feb 3, 2013
    #4
New Posts