I have a 1966 CJ5 that has Summers Brothers aftermarket 1 piece flanged axles in the dana 44 rear and dana 27 front with t-10 4 speed, warn...
I'm looking to replace my 232 motor with a fully complete 258 motor. I would like to have previous run well and be relatively clean. Any offers...
Garage clean out! Heater Box and Hose 25.00 LED Tail Lights. New, in boxes. 45.00 Brake lever arm. 15.00 Used Wheels 15” Set of 5. 200.00 Master...
72 CJ5 gas tank
I have recently acquired a 1963 CJ5 with a 1969 Dauntless 225 ci V6. It has a Dana 44 rear end with a solid, 1-piece axle, full floating. On my...
Hi, does anyone have drawing/plans/schematic to build a roll bar? It is to fit a 62 CJ5. Thanks!
The PO of my ‘71 cj5 put custom pipes on, but they are straight from the manifold out the side with no muffler. Does anyone have any suggestions...
I just finished dealing with a carburetor flooding issue which was detailed in an earlier thread here. Now it runs very well but there is a...
Can anyone suggest a good set of hanging pedals for a 62 CJ5? Not from a "newer" jeep, we do not have them down here in South Florida. I am...
Hi, I am about to start the front floor replacement. I originally got the jeep with barely any of the original floor to go by. I want to make the...
I have no spare and I need help identifying my rims to see where can I get another. Thanks![ATTACH]
I have a 62 cj5 with a Dana 25 in the front. I noticed the yoke has a considerable play in-out. I opened the pumpkin and parts look somewhat ok....
My ‘71 with factory Dauntless is giving me grief. I can’t get it to stay running. I have a new fuel pump, new plugs, new wires new coil, new...
After posting some random pics about my jeep in some random threads I decided (Focker suggested) to document it all here in a more coherent way. I...
Can anyone tell me the part numbers for the kingpin bearings for a 62 CJ5 Dana 25? Thanks!
Will late 70's stock CJ-5 roll bar fit 1964 CJ-5? One is for sale locally but I'm not sure if the tub dimensions changed between those model years.
Hello everyone, and thanks for all of the awesome content on this site! It's been very helpful in my adventure to get this old CJ running. Before...
Are the front and rear struts of a 62 CJ5 different? Some pages sell them as interchangeable, while Kaiser Willis have two different part numbers....
Does anyone know where can I get parts (bearing, center spline) for these hubs? One of the bearings is shot and the center spline for that one is...
Has anyone replaced the under seat fuel tank of a cj5 for a tank in the rear but without relocating the fuel port on the side? I want to put the...
Separate names with a comma.
