So turns out the battery was bad. I'm assuming it was for a bit even though it was only 13 months old. The original solenoid I had changed out was...
That's why I replaced it in the first place, the old one would just click once when turning the key. The new one does nothing. Definitely possible...
One of the first things I did was give it a smack
The battery was purchased 13 months ago, not that that makes much of a difference. But I was having zero issues at all until I replaced the plugs,...
Well I had my truck hooked up (brand new cummins) and it still did nothing when turning the key. Starting to think maybe the ignition switch? Had...
I'm going to hook my truck up again and see what happens. Battery is showing 11.6 volts but I have to buy a new multimeter tonight on the way...
I did that right before it got dark. I forgot to have the key on so all it did was spark a few times and then nothing
So I replaced the solenoid, wired it like the original and now I get absolutely nothing when turning the key. Dash lights up, but no click or...
Battery is a year old, and reading right at 12 volts. A little low, but has been enough to start the jeep up until I removed the starter to repair...
So if I have this right, the 4 terminal solenoid will work in place of the 3 terminal. I'll just have to swap over the copper tube and then leave...
This is the replacement I can get from oreillys. It shows 4 terminals but I don't see how I would wire that with my current configuration
Okay, so here is what I have. I also just picked up a new connector for the small ignition wire, so don't mind the wire wrapped around the post.
So I have the main power from the battery, and a wire from the ignition, that's it. I'll grab a picture here in about 2 hours when I get back there.
Solenoid hasn't been replaced yet. Also, all of these replacement solenoids look different than mine. They show 4 terminals but mine only has two.
Hey guys, Coming here for help after a day of struggling. Finally home from deployment and able to put eyes and hands on my new to me 71 CJ5 with...
That's what my research has shown too. Some have mentioned HEI distributors as well but I feel that there will still be too much noise. As long as...
Good eye on that! Honestly, I bought the Jeep after only seeing pictures. Had my wife go look at it and make sure there was no rot and that it ran...
That's the answer I got from Holley, and BJ's is exactly where I saw the kit. Wondering if it's work taking a shot on it.[ATTACH]
Oh I plan to, I noticed that when my wife sent me the pictures. I'm assuming it's supposed to have a line that runs to the intake. I'll probably...
I did see that, and I'm 99% sure it'll work without an issue. But I wanted confirmation from them before I spend the $1300 on the master kit.
Separate names with a comma.