I think your bearing is attached to the shaft: [ATTACH]
I have the Oil Scoops. Just removed them for the photos.
I was comparing 2 overdrives side by side and I noticed that one of them has a bearing in the center and the other does not. [ATTACH] The other...
I took a couple of short videos of my engine running with a vacuum gauge attached. Here it is at idle (about 700 rpm): [MEDIA] And here it is...
Far from being frustrated, I'm happy it broke in my hands instead of after I installed it.
I found my wayward LUK fork. Here are some photos to compare it to my rusty replacement fork: [ATTACH][ATTACH][ATTACH] The metal frame looks...
For reference, here is a single stick: [ATTACH] And here is a twin stick: [ATTACH] The twin stick is a lot shorter.
I also have the Speedhut gauges. I installed them 1 year ago and so far they are great. If you don't need original gauges then I highly...
jeepdaddy2000, I did remove the front bearing retainer, and that did allow the gears to separate a little bit. It's possible the bearings are...
[ATTACH]
My CJ6 has an SM420 transmission that has been shifting poorly. I pulled the transmission and found a bit of wear on one of the synchros. I'm...
I have an SM420 in my CJ6. Oil was dripping from the bell housing and the advice I got was that the rear main seal was leaking. After some testing...
I have an SM420 in my CJ6. The shift lever was really loose because the pins in the tower were almost completely worn off. I removed the pins...
I am also interested in finding a new master. Mine from Herm also leaks, but only a little. Mine leaked from day one. And I bought it long before...
My CJ-6 was missing the gas pedal. I ended up building a pedal out of a scrap piece of 1/2" cold rolled steel. [ATTACH]
I don't know. I installed the used fork I purchased and put the LUK fork on the shelf, and somehow the LUK fork has disappeared. If I ever find it...
My tow bar drop is about 4 inches from the CJ-6 to the receiver on the Grand Cherokee. I thought the tow bar should be level, so I bought a 2"...
I have an NSA tow bar with the integrated braking. It seems to work well. Here is my 1967 CJ-6 behind my 2006 Grand Cherokee. [ATTACH] I don't...
I have that mount. It seems to hold the extinguisher well. [ATTACH]
I ran my V6 exhaust around the front of the engine, so I extended my fuel pump heat shield. I was not having an issue, but it seemed like a good...
Separate names with a comma.