Looking for fabrication ideas since I cannot locate a new weld on part. I need to replace the driver side steering limiter on the front axle....
Correct the backing plates were not with the axle when I dropped it off.
I appreciate that. I did order the Timkin 11520 and they sit nearly flush with the knuckle. The slight difference maybe from removing rust is...
Hoping I can flatten the old retainers out. Either way axle is getting pulled.... Maybe sources different retainers though. The backing plate...
Over by LaValle/Reedsburg area. I put my boat in at Sheboygan Harbor though!!
I prefer Timken bearing anyway. Especially the old ones. The old races are gone, no more comparing so I will order the Timkens and compare to...
So, Also just received back from the Transmission shop my front end. I went to start putting the knuckles back on and went to install the new...
Ok. I am rebuilding a 1971 CJ5 Dauntless frame up. I had sent my Dana 44 to a transmission shop to have it completely disassembled, inspected,...
That's the cool part. It is the I6 retainer that is original on the V6 engine...….. It also has the bellhousing w/o adaptor.
Not sure. It appears that my 1971 CJ-5 was manufactured 11/1970. From Herm it has the I6 bearing retainer that probably was not used in 1970...
Does anyone know where I could find a very good condition bearing retainer for a T14 Transmission?
Yes, That is what I meant to say. Keep the Dana 18 current gears and set up and just move over to a Dana 20 case. I was able to locate the same...
OldTime - Excellent information!! I was able to locate a D20 with the same casting numbers (version - 5) online. Saving this post for the...
Great information. What I gather is that if I can find a Dana 20 casting that matches my C18-15-24-5 Dana 18, then I could swap out gears move...
I have a 1971 CJ5 Dauntless I am restoring. The Dana 18 transfer case has been broken and welded. I was going to replace it though it is...
So I have a 1971 CJ5 that I am rebuilding. Converting to Saginaw box. I see this thread is before 1971. What is different about the 1971 CJ5?
Does anyone have a schematic with the frame measurements for properly positioning the motor mounts of the V6 Buick 225?
Good to know. The guy was quite the salesman. Frame was way overpriced. Definitely not worth a trip out to Colorado for.
Off the wall question. I found a frame out west. The guy said it is on a 1971 CJ-5 with a V-6. But, he then said it was on a Special Edition...
So, looking for a rust free / damage free frame for a 1971 Jeep CJ-5 w/ Buick 225 motor mounts and a NT CJ Dana 30 front end w/ any gearing so I...
Separate names with a comma.