Thanks for the info. It was mentioned a few times that my problem may be a bad cam gear. Short of removing the front cover are there any tricks...
Noise is present after warm up when engine is revved up in nuetral and especially present when pushing snow under load. Given that the noise...
was plowing the other day and started hearing knocking noise. Noise was more present under load. Noise is not apparent when engine is cold. Once...
what vacuum reading is typical for a healthy F134? I’m only getting 14-15hg. I tried to adjust ignition timing with no improvement. I’m taking...
Not sure I understand? Can you explain? Thanks
I don't
I installed an engine in my 1963 that I bought used. The PO said it ran fine and had low hours on a rebuild. Engine runs good but lacks some...
Anyone know what brand/model this plow pump is? It mounts to the driver's side from a bracket that is fastened using the 2 head bolts. Actuator...
Looking for some info on power lock LSD units. I am looking to buy them for the front and rear of my stock 63 CJ5. Is there anything I should...
All, need some help. I'm helping out a friend who has a 1976 CJ7 with a 304 V8 and 3speed Manual. It does not have Quadra-Trac. He needs to...
I have the same problem with the pump on my Jeep. Lifts very well when cold and performs worse when warmed up. I tried changing the fluid, I...
So basically my choices are: Lock Right Power Lock Detroit Locker with additon of FF axles ??? Anyone now of any other options for a...
I thought about welding the diff but decided otherwise. I want to be able to put it back to OE if I choose. Tim, do you know a source for a...
I am researching traction devices for my 63 CJ5 with the stock Dana 25 front and Dana 44 rear. It seems there are limited offerings out there...
Thanks for the help guys.
Need some help on this. Another question I have is how much higher do you sit with a bench seat vs. the original equip. low back bucket. From...
Are these things hard to come by? I found one in fair condition for $200, is that a fair price?
Thanks to all for the great insight. I'll check the axle gears and go from there. That's what you have to love about these projects. Every...
Regardless of whether I have 4:27 ot 5:38s, is an axle gear swap my best choice for reclaiming a good crawling gear? I could swap out transfer...
Thanks guys. I'll check out the axle gear ratios this weekend.
Separate names with a comma.