I drive through Marysville often. I'd love to check out your Jeep.
I used Isspro gauges on my M-715. I'll be using Isspro again to do my cj-6 gauges. I'm installing a dash out of deuce and half so I'll have the...
That is a nice looking kit. I'll be making my own out board leaf spring mounts. Lots of fab work to do, and not much if any time right now....
My build is a 1966 cj-6. Rebuilt 225 dauntless, sm420 trans, dana 18 tera low with overdrive. 1974 wagoneer dana 44 axles springover. I have...
Lets see who posts pictures first?
I'm working on the same project right now. I have it figured out, and I have the materials. Now I just to get it done. I'm using new rear...
I did a test of a few small tack welds on the bottom boss where the spring used to sit . I can't knock them off with a hammer, they are on there....
Thank You, Everything is pretty much clean,maybe a touch more with a fan disc, re measure everything and I'll burn it in hot. I have an old...
Thank You, that's good to know. I'm just wanting to weld a new mild steel spring perch on top of the cast steel center section above the factory...
I am currently working on finishing boxing my frame and starting to install my soa suspension on my 66 cj-6. I have a question. What is the best...
I'm pretty sure I read on Holbrooks website they don't recommend using their springs in soa applications. You could use modified rear wrangler...
I think your right. I can pull the twist out just by adding weight on the opposite corners. I'm going to leave the weight on their for awhile....
It's been awhile since I worked on the cj-6. Now with two boat projects behind me I'm back at it. I have noticed my frame is twisted, just a...
Thank You. I'll measure the 79 axles and see if the earlier ones are a bolt in. Just looking for options before we decide to regear the stock axles.
My brother has a 79 cj-5 that we are building. I was wondering if anyone knew the axle width of the amc 20 rear end and front dana 30? We were...
I used the Novak bracket and their slave for my M 715. I had to modify the bracket, purchased a jeep master from a cherokee later model of the...
Sounds like your getting close to finalizing your plan. I have mine and hope to stick with it. Nicely built 225, sm420, dana 18 tera 3.15 low...
If you have the means, sandblasting is the best method. Otherwise I've found a 5" random orbit sander hooked up to a shop vac. Start with about...
My 715 has the stock axles and gearing, front disc. conversion. Those wheels were custom made by MRW wheels in Arkansas. The truck looks pretty...
[IMG] My 66 cj-6 is undergoing frame boxing and modifying. 225 already built, sm420 done, dana 18 tera low, twin sticked and overdrive...
Separate names with a comma.