Here's a place for South East guys. I have no experience with their products, but if you are looking for this kind of thing here you go....
It seemed like they served a purpose but they were so rusty and mangled I had no idea what they were, thanks Posted via Mobile Device
here is what I got finished today, it's almost ready for the powder coat shop. Do any of you guys know of any problems with powder on the axles...
I just got the motor lifted out via carpenters pully and oak tree, and I'll be stripping everything else off the frame tomorrow morning. pics...
Conway, the county seat of the independent county and home to bowlegged swamp-women
I've got a pretty run of the mill ECJ5, dauntless V6, T90, Dana18 transfercase, 27 in the front and 44 in the rear, and a 2jet carb that has left...
Im going to finally re-do my jeep now that Im not chasing an imaginary post-graduate career. I tried to get some info for a quick fix a few...
Might not need to go for the jeep at this time, I've got an interview tomorrow for a job so I may be able to stay in NY. If not I'm going for the...
The frame is in good shape, no rust other then a little surface stuff. From what I can see from underneath I'm not in too bad of shape. After...
You guys are definitely siding with the voice of reason in my decision. The jeep was my DD up until the carb/timing issue, which after 3 trips to...
Hello everyone, I am about to undertake a jeep rebuild to a daily driver not out of pleasure but out of necessity. I just graduated college moved...
Hey there, Im over here in Horry County with a Dauntless and Im about to do a complete re-build of my 63 CJ-5. I was thinking of buying a...
I've called NAPA, but they need the model number off the Carb. The issue is that I can not find the number for the life of me. I've found diagrams...
my carb is in need of either a kit or replacement. Where did you buy your kit from? And what would be the least expensive way to replace it?
Separate names with a comma.