Several years ago (with advise from many folks here) I swapped out my original T-14 with a T-18 from another CJ of the same year. OEM spacer,...
Okay...I put in a new clutch and throw out bearing when I swapped in the T-18. Then I converted to a hydraulic clutch release in place of the...
While I have a mechanical coolant temperature gauge mounted in one of the water jacket block openings, I have always wanted to add an aftermarket,...
I have swapped my clutch release mechanical linkage for a hydraulic system. I'm using a Wilwood 7/8" master cylinder with a Novak 3/4" slave. This...
Has anyone ever tried to swap a T-18 aluminum shift forks into a T-18 that has cast iron forks? Sort of a long shot. The cast iron forks are in...
With the Torque Snubber issue resolved I got the machine on the road. I rebuilt the T-18 using the Novak kit..... New front/rear bearings, new...
Okay as I have indicated in a previous thread I am transplanting a T-18/Dana 20 from a 1974 CJ5 into another 1974 CJ5 that previously had a...
I just pulled the transmission out of a 74 CJ to replace the clutch. The pilot bushing was loose enough that I could pull it out with my fingers...
I'm in the process of rebuilding two Dana 20 transfer cases. One out of my 74 CJ5 and another out of a CJ5 70 something. I have two different...
I have finished up my T-18 rebuild and getting ready to button it up until the install. I don't have a real good feel for just how hard it should...
A few questions: Will the disk brake parts from an 80 CJ (axle flange out) bolt in place of the 74 drum parts? Will I need to change the...
If one relocates the spring perches on a set of Commando axles to match the CJ locations will the entire drive train then be transferable to a CJ?...
I putting the transmission back together and while following the directions from several sources I cannot find what the actual clearance is for...
I'm getting ready to swap my old bolted together cast iron intake and exhaust manifolds for a later model aluminum intake and new cast iron...
I have the chance to get a Jeep V6 out of a Commando. Unfortunately the engine was mated to an automatic. I have searched and in one instance I...
Does anyone know what vehicle utilized an AMC 258 /T18/D20 with the starter located on the driver side diagonally opposite the CJ location?
I'm getting ready to swap my 70 something iron manifold for an 80 something aluminum manifold. (exhaust manifold as well of course) Can I...
These Warn manual hubs were on a 74 CJ I ended up using for parts. They take a special locking ring in place of the normal nut and bent washer...
Does anyone know if there would be any problem using the D20 shift linkage setup that was utilized in the 71-74 J-10 in a CJ5? I'm swapping from...
Almost everything I read says to make sure and mark the flywheel in relationship to the crankshaft so it can be replaced in the same position it...
Separate names with a comma.